Ebony for bolsters

[Dave Barker]

Hi.

I am struggling a bit.

i have no workspace to set up a mitre saw so wonder if there is anyone who might just happen to have a couple of ebony off cuts needing a new home?

would need a 4 of bits cut at straight angles they need not be more than around 1.5 cm thick.

i would ask that they be planned flat on one side though?

Anyone?

[Bazza]

Dave,
checked out my favourite wood shop today, but no thin pieces of Ebony. I know I have some pieces somewhere, memory says about 25mm square by ? thick. Will have a dig around tonight and let you know.
Barry

[Dave Barker]

Dave,
checked out my favourite wood shop today, but no thin pieces of Ebony. I know I have some pieces somewhere, memory says about 25mm square by ? thick. Will have a dig around tonight and let you know.
Barry


Thanks mate. Pm me if you have any joy!

[Kisu]

I have a lot of African blackwood slabs and blocks - photos below:

http://i6.photobucket.com/albums/y211/Kisukali/africanblackwood_1.jpg

http://i6.photobucket.com/albums/y211/Kisukali/africanblackwood1_1.jpg

You can guess the dimensions from the cigarette packet etc :D Let me know if any pieces are of interest and I will post to you FOC.

Cheers,

James

[ZDP-189]

As always, PM me if you still need some bits, Dave