Tutorial: Wood sheath with leather braidsTutorial of wood sheat with leather braids.
Photos of the ready sheaths:
I have added some English text to photos.
I'm sorry, I haven't any tutorials with English text, only with Finnish text.
But however photos show the ways to make that sheats in that tutorial.
Here is the link to Finnish tutorial.
Wooden sheat with leather
I hope that those pages will open all around the world.
Perhaps some later I can add English text too ?
Here below I joint someone photos of that wooden-sheat making:
In my Damask gallery are some that kind sheats with knives too.
Here you can open it by this link:
- '); loadVbCss(yuipath + '/treeview/assets/skins/sam/treeview.css'); //-->
Recent Forum Activityavoidspam
Thought I'd give this a go. Sorry if it's been tried before but I quite like the version on the other side of the pond. Everyone gets a bit creative with their camera's... Plus it's a nice opportunity to see what's out there....:) SamLast Post By: bagman Today, 04:36 PMBasemetal
Stumbled across this recipe by Dave Roberts on mudandroutes.com http://www.mudandroutes.com/porridge-bread-ultimate-mountain-carb/ Heavy bread and porridge tick two boxes for me :D I'll report back... EDIT: It's a success. So here's a transcript of the recipe in case the linked page...Last Post By: Noddy Today, 03:24 AMgregs656
In need of a panel loading back pack for long weekend/weekend travel. Budget is the lower the better and I am more than happy to go used - I have lots of bags and I don't expect this one will get tons of use, but it will be very useful to fill a niche. I have an Osprey 80 which I have been...Last Post By: gregs656 Yesterday, 10:59 PMChrisBee
I'd imagine it won't be cheap, the xm-18 goes for about $400. Hopefully this will come in at less than my recent laptop cost me. http://www.thetruthaboutknives.com/2017/02/hinderer-debuts-slipjoint-folder-prior-to-iwa-show/Last Post By: earthman Today, 04:38 PMginda
Hi all Very excited about joining the forum. I am hoping you could help me get started with forging my own blades. 1. Need a forge that can heat up to forge welding temp 2. Need a forge that will accommodate sword lengths? 3. Not sure if I should get a coal or gas forge? 4. Are gas forges...Last Post By: polemat Yesterday, 11:01 PMfjohansson
Hi all! Just a question.. Does anyone know where to find clips similar to the Spyderco "G-Clip" or Blade Tech "Klip" here in europe? I know that I can order them from the States (like from knifekits.com etc) but the shipping is a little too expensive for me.. I'm basically looking for clips...Last Post By: dvd8n Today, 01:35 PMkeen-edge
Hi fellas I got a PERFECTO LATHE it came with all the gears but unsure were they go I found the thread cutting chart it says what gears I need to cut a thread but don't say where they have to go on lathe yep I am thick but never had a lathe before any help please cheersLast Post By: keen-edge Yesterday, 05:28 PMpeted
I'm still going through my stag box, this is a Taylor's "Eye Witness". Its a long knife with a violin or swell centre shape with a long blade measuring 3.5" but would have been another 0.25" if the tip was still there. The small blade is about 2.5" long and again it has lost a little bit off the...Last Post By: OWDTOM Today, 12:47 PM